Price:
US$23.95

Free Shipping


Overview and Specifications:

NOTE: This is a presale item, all the orders will be shipped out on April, 25th probably.

Overview:
1. ESP32 is a complete,small form factor(SFF)802.11 b/g/n/e/i(2.4GHz) WLAN plus BT4.2combo solution optimized for low-power,mobile consumer electronics,wearable and Internet of Things(IOT) devices.ESP32 integrates all WLAN and BT functionality in a single package to support a low cost,layout-friendly implementation while allowing flexibility for platform specific customization.
2. ESP32 is a highly integrated solution with less than 10 external components.
3. ESP32 integrates the transmit /receive RF functionality including the antenna switches,RF banal,power amplifier, low noise receive amplifier,filters,power management,and advanced calibration circuitries that allow the solution to dynamically adjust itself to adapt to external circuit inflections.
4. The entire solution reduces Printed Circuit Board (PCB) area,time-to-market,and bill-of-material(BOM)costs while adding capabilities and processing power.the mass production of ESP32 does not require expensive and specialized Wi-Fi test equipment.
5. ESP32’s ultra low power consumption radio architecture and proprietary power save technologies extend batter life in real-world applications,using the following features:a. Fine granularity clock-gating
b. Multiple low-power modes
c. Dynamic voltage scaling For instance,in a low-power IoT sensor hub application scenario,ESP32 is woken up periodically and only when a specified condition is detected;low duty cycle is used to minimize the amount of energy that the chip expends.The output power of the power amplifier can also be adjusted,so that an optimal trade off between the communication range,data rate and power consumption is achieved.

Basic Features:
Wi-Fi
802.11 b/g/n/e/I
802.11 n (2.4Ghz), up to 150Mbps
802.11 I security features: Per-authentication and TSN   
802.11 e:Multiple queue management to fully utilize QoStraffic prioritization       
Wi-Fi Protected Access (WPA)/WPA2
Wi-Fi Protected Setup(WPS) 
A- MPDU and A-MSDU aggregation   
Fragmentation and defragmentation    
SSL stacks with hardware accelerators
Automatic beacon monitoring / scanning
Infrastructure BSS Station mode/ Soft AP mode
Wi-Fi Direct (P2P), P2P Discovery, P2P Group Owner mode and P2P Power Management
UMA compliant and certified
Antenna diversity and selection
WMM power save U-APSD

Bluetooth
CMOS single-chip fully-integrated radio and baseband
Bluetooth Piconet and Scatter net
Bluetooth 4.2(BR/EDR/BLE)
Adaptive Frequency Hopping(AFH)
SMP
Class-1 ,class-2 and class-34 transmitter without external power amplifier
+10 dBm transmitting power
NZIF receiver with-90 dBm sensitivity
Up-to 4 Mbps high speed UART HCI
SDIO/SPI HCI
Low power consumption
Minimum external component

CPU and Memory
Xtensa?Dual-core32-bit LX6 microprocessors,up to 400 MIPS
128 KB ROM
QSPI Flash/SRAM,up to 4x 16 MB
Power supply: 2.5V to 3.6V
416 KB SRAM
 
Clocks and Timers
2 MHz to 40 MHz crystal oscillator
Internal 8 MHz oscillator with calibration
External 32kHz oscillator for RTC with calibration
Internal RC oscillator with calibration
Two timer groups including 3×64-bit timer and 1x watchdog in each group
RTC timer with sub-second accuracy
RTC watchdog

Advanced Features:

Advanced Peripheral Interfaces
12-bit SAR ADC up to 16 channels
2×10-bit DA converters
10x touch sensors
Temperature sensor
4sSPI
2xI2S
2xI2C
2xUART
1 host(SD/eMMC/SDIO)
1 slave(SDIO/SPI)
Ethernet MAC interface with dedicated DMA and IEEE 1588 support
CAN 2.0
IR(TX/RX)
Motor PWM
LED PWM up to 16 channels

Security
IEEE 802.11 standard security features all supported,including WFA,WPA/WPA2 and WAPI
Secure boot
Flash encrypt
1014-bit OTP,up to 768-bit for customers
Crytographic hardware acceleration:
AES 128/192/256
HASH(SHA-2)library
RSA
Random Number Generator
 
Applications
Generic low power
– IOT sensor hub
– IOT loggers
Audio & Video
– Internet music players
– Audio headsets
– Wi-Fi + Bluetooth audio streaming devices
– Video Steaming from camera
Wi-Fi + Bluetooth enabled
Over The Top (OTT) devices
Smart devices  
Wi-Fi enabled 
Loggers toys  
– Proximity sensing toys 
– Speech recognition devices  
Home automation
– Smart plugs
– Smart lightings
Industrial automation
– Industrial wireless control
– Mesh network
Security ID tags
Sensor network
– Wi-Fi location-aware devices
– Wearable electronics
– Baby monitors
Health care
– Proximity movement monitoring
– Trigger devices
– Temperature sensing loggers

Development Support
Firmware and SDK for fast on-chip Programming
Open source tool chains based on GCC

General
Model ESP-WROOM-32
Quantity 5 pieces
Form  Color Dark blue (5PCS)
Material PCB + electric component
Specification
Chipset Xtensa® 32-bit LX6 microprocessors
Download Link http://www.espressif.com/en/products/hardware/esp32/resources
Other Features
Certification CE

Packing List:
eSP32 Modules

Leave a Comment